Subversion Repositories f9daq

#include <SPI.h>
#include <Adafruit_MAX31865.h>

#define RREF 430.0
#define RNOMINAL 100.0

Adafruit_MAX31865 max = Adafruit_MAX31865(10, 11, 12, 13);
int pinOut1 = 2;
int pinOut2 = 4;
int state1;
int state2;
void setup() {
  pinMode(pinOut1,OUTPUT);
  pinMode(pinOut2,OUTPUT);
  digitalWrite(pinOut1, HIGH);
  digitalWrite(pinOut2, HIGH);
  Serial.begin(115200);
  //Serial.println("Temperature");

  max.begin(MAX31865_4WIRE);

  
}

void loop() {
   char incomingByte;
   if (Serial.available() > 0) {
    // read the incoming byte:
    incomingByte = Serial.read();
    
    // say what you got:
    if (incomingByte == 0){
      digitalWrite(pinOut1, HIGH);
      digitalWrite(pinOut2, HIGH);
      //Serial.println("low");
    }
      else {
      digitalWrite(pinOut1, LOW);
      digitalWrite(pinOut2, LOW);
      //Serial.println("High");
    }
  }
  
  uint16_t rtd = max.readRTD();                                                                                                                             
  float t = max.temperature(RNOMINAL, RREF);
  state1 = digitalRead(pinOut1);
  state2 = digitalRead(pinOut2);

/*
  Serial.print("RTD value: "); Serial.println(rtd);
  float ratio = rtd;
  ratio /= 32768;
  Serial.print("Ratio = "); Serial.println(ratio,8);
  Serial.print("Resistance = "); Serial.println(RREF*ratio,8);
  Serial.print("Temperature = "); Serial.println(max.temperature(RNOMINAL, RREF));

  // Preveri in vrne vrednost napak
  uint8_t fault = max.readFault();
    if(fault) {
      Serial.print("Fault 0x"); Serial.println(fault, HEX);
      if (fault & MAX31865_FAULT_HIGHTHRESH) {
        Serial.println("RTD High Threshold");
      }
        if (fault & MAX31865_FAULT_LOWTHRESH) {
          Serial.println("RTD Low Threshold");
          }
           if (fault & MAX31865_FAULT_REFINHIGH) {
            Serial.println("REFIN- < 0.85 x Bias - FORCE- open");
            }
              if (fault & MAX31865_FAULT_RTDINLOW) {
                Serial.println("RTDIN- < 0.85 x Bias - FORCE- open");
                }
                  if (fault & MAX31865_FAULT_OVUV) {
                    Serial.println("Under/over voltage");
                    }
         max.clearFault();
        }
  */
 Serial.print(t);
 Serial.print(" ");
 Serial.print(state1);
 Serial.print(" ");
 Serial.println(state2);
 //Serial.println();
 delay(1000);
}