Subversion Repositories f9daq

{

TVector3 dum;

gROOT->ProcessLine(".L src/RTUtil.cpp+");

gROOT->ProcessLine(".L src/guide.cpp+");

gROOT->ProcessLine(".L src/raySimulator.cpp+");

gROOT->ProcessLine(".L src/userFunctions.cpp+");

// Set the parameters of the light guide:

// SiPM0: light guide exit surface linear dimension (surface = SiPM0^2)

// M0: Magnification ratio = b / SiPM

// b: Light guide entry surface linear dimension = M0*SiPM (surface = (M0*SiPM0)^2)

// d0: length of light array

// n10: refractive index outside of the light guide - entry surface and lateral sides 

// n20: refractive index of light guide material and the glass plate

// n30: refractive index outside of the light guide at the exit surface (ie optical cement, detector) - it is used only by Fresenl eq, not for the refraction

gROOT->ProcessLine("SetLG(3.0, 5.0, 3.0, 1.0, 1.53, 1.0)");

// Set light guide surface types

//

// void SetLGType(int in = 1, int side = 1, int out = 1)

// 0 = dummy; 1 = refractor; 2 = reflector; 3 = total reflection (oboslete, total reflection now included with refractor type)

//

//gROOT->ProcessLine("SetLGType(1, 1, 1)");

 // Gap between light guide exit surface and sensitive area (SiPM)

 // supposed it is epoxy of the same refractive index as light guide

gROOT->ProcessLine("SetGap(0.3, 0, 0)");

// Glass surface of the detector on/off; width

gROOT->ProcessLine("SetGlass(0, 0)");

// Glass plate above the light guide on/off

gROOT->ProcessLine("SetPlate(0, 0)");

// Draw the detector and propagate certain number of rays

gROOT->ProcessLine("Show3D(1)");

// Draw the statistics

gROOT->ProcessLine("ShowData(1)");

// Propagate 1e4 rays, isotropicaly distributed in 0-30 degree cone (relative to entry surface normal)

// draws first 20 rays (slow)

gROOT->ProcessLine("LGS(0,1.6,2.0)");

//gROOT->ProcessLine("LGI_ad()");

//gROOT->ProcessLine("LGS()");

}